15th August 2004 13:30 UTC
AVS fullscreen
My avs full screen isnt quite full screen :igor:
14 inch monitor 11mb video WA 5.04
I'm probably a bit retarded here.
Archive: AVS fullscreen
protegechris
15th August 2004 13:30 UTC
AVS fullscreen
My avs full screen isnt quite full screen :igor:
14 inch monitor 11mb video WA 5.04
I'm probably a bit retarded here.
Rovastar
15th August 2004 13:38 UTC
AVS editor --> Settings --> Fullscreen --> "Vertical screen height to render (percent)" and type in 100
protegechris
15th August 2004 13:44 UTC
thanks , now theres stillsome space on the right side, I tried changing the resolution of it to 800x600 but it just flashes to the avs, then switches back to the normal screen.
Rovastar
15th August 2004 14:17 UTC
Ummh dunno mayeb those with more AVS knowledge willl be able to help.
Moving....
PAK-9
15th August 2004 14:37 UTC
You could try setting the vertical height to render to be 99 rather than 100, that causes glitches sometimes. You might want to move that performance slider at the bottom a lot closer to 'higher framerate' as the lower thread priority could be screwing something up.
Other than that I'm not sure, maybe you could post a screenie of it in fullscreen doing the wierdy.
protegechris
15th August 2004 14:45 UTC
Well thescreenshots make it look like it takes up the whole screen. The slider is now all the way to high framerate.
Anything bigger than 400x300 jsust flashes the AVS then returns to normal screen, anything equal to or smaller leaves the gap on the right:igor:
Alsos set the vertical height to 99, no success.
PAK-9
15th August 2004 14:58 UTC
It could be that your attempting to switch to a video mode that isnt supported by your monitor (I just noticed its only 14 inch), perhaps you could turn down the refresh rate to 60hz. Also try switching off wait for retrace, and if you havent already, try using 32bpp resolutions.
Fork me on GitHub